Saturday, December 12, 2009

Wrapping tables up


So many glue ups! It took some time but the bases and the frames are all glued up.
I glued the frames first so that while I was waiting for the base glue ups to set I could...


Fit the panels in the frames. I have been waiting for this for a long time ha. Logistically it's the trickiest joint of the piece as it is loaded from the top and I want to get a tight fit all the way around the panels. They went pretty well though.
After the bases were set I planed off the last remaining "breath" of the aprons over the tops of the legs.


Then moved on to finishing the panels and the parts of the frames that hadn't been finished yet.
For the for the frames I used some Clapman's wax on top of Shellac, the same as the base. For the panels I wanted to add more protection because this is the main surface that will be used. I tried some floor wax but didn't like the out come... it was too shiny. I opted for a paste wax from Liberon which seemed to produce the finish I was looking for.
The bottoms of the panels are taped off for the glue up to come.


This is just that. It would be easier with a vacuum press or something. I think that went I get to the coffee table I'll try to borrow one.
In between some of these steps I also cleaned up the brass brackets and did the drilling for all the little #4 screws. Basically I'm just waiting on these panel glue ups, one at a time. Then I'll have some side tables yay... I certainly hope all goes according to plan!

3 comments:

Nick Brygidyr said...

It's nice getting stuff done every now and then isnt it haha.

have you checked out joewoodworker.com? i got plans for my vacuum bag from him, it's super easy, dosent cost too much and best of all, it works!

im gonna build a bending iron out of a can and a 200watt lightbulb pretty soon.

Unknown said...

Hi nicholas,

My name is Aaron Scaturro, I am interested in attending Inside Passage, and dont know where to begin, as an American student. you can reach me @ a.m.scaturro@gmail.com. I have a few questions for you if you dont mind getting ahold of me...

I like your work!

Nick Brygidyr said...

Merry x-mas dude!